Farmall & IHC Tractors Discussion Board |
Re: Re: super M wiring help for novice
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob Murphy on October 23, 2003 at 05:37:19 from (198.160.193.228):
In Reply to: Re: super M wiring help for novice posted by Bob M on October 22, 2003 at 14:11:46:
I've got a pull switch to allow the tractor to start. Then I've got the foot switch to actually start the tractor. There's another switch near the pull switch which I'm guessing was for the lights (which aren't hooked up). When I recently bought the tractor the guy told me to jump a wire from the positive terminal to the top left wire on the regulator when it stopped showing charge on the ammeter. Tractor is covered in snow at the moment, but it's supposed to melt by the weekend. I think I'll pull apart that black box and check for fuses. Do you think it is worth having the generator rebuilt, or should I think about doing the alternator conversion? Thanks again for everyone's help. I'll probably be looking for more after the weekend.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|