Farmall & IHC Tractors Discussion Board |
Re: yippee! pivot shaft is out! now what?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Larry in CO on September 30, 2003 at 15:59:12 from (32.97.110.142):
In Reply to: yippee! pivot shaft is out! now what? posted by bill on September 30, 2003 at 13:29:15:
Bill, You're correct that the bottom bushing will be driven out from the top. I also drove the top bushing out from the top. This caused the seal that is positioned below the top bushing to come out as well. When I put the new top bushing in, I put it in from the top as well. The hard part was getting the new grease seal in. That had to be put in from the bottom. I forget now what I used to put the seal in with, but I do know that it made it a whole lot easier to put it in while I had the bolster off and laying down. HTH. Larry
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|