Farmall & IHC Tractors Discussion Board |
Re: OT: Loader cylinder rust
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Brian on September 29, 2003 at 12:31:34 from (65.48.189.192):
In Reply to: OT: Loader cylinder rust posted by bbauman on September 28, 2003 at 22:56:17:
If your cylinders are only single acting ( hydraulic to raise, gravity to come down ) then you don't have to worry about the seals leaking on the rod end. You should try and clean them up as best as possible though becauser there may be some light seals in there just to keep water from getting in there. If it is like the laoder on my 50's super A, the seals on the cylinder rod are leather and may need replacing. Furthermore, you might want to try sanding the inside of the cylinders between the end of stroke and where the piston was situated. If there is rust there is may chew up the rod seals too. If you do need to replace the cylinders, email me, I may be able to get some cheap for you. Brian.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|