|
Farmall & IHC Tractors Discussion Board |
Re: Info on a Super H engine
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dr.EVIL on September 10, 2003 at 06:42:34 from (12.4.181.2):
In Reply to: Info on a Super H engine posted by Jesse on September 09, 2003 at 09:00:28:
My Super H was built about 1-7-1954 according to FARMALL records. The engine serial number is 2800 numbers higher than the tractor chassis serial number. Date codes on the block & head castings confirm this being late Nov. & Dec. '53. The 358067-R1 is the raw block casting number, which is the same part number My C-164 has. I know the C-164 can have thin-wall sleeves & over-size pistons installed to make 3-9/16" bore for 169 cid. but it is still a C-164. The 300/350 parts book I have shows that a 300/350 (C-169 or C-175 should have a 364265-R1 block or 362743-R1. The C-164 is located right above the oil filter and is raised cast lettering, kinda hard to read.... Without actually seeing it I'd say You probably actually have a C-164 because of the 358067-R1 casting number, probably the original engine installed in that Super H at FARMALL. There was some coring changes done in the block castings to allow larger diameter sleeves & pistons to be installed in the 300/350's. You couldn't put over-size sleeves in either engine without boring the block, and if the cores shifted enough, sometimes You ran out of iron to machine, scrapping the block. Both IHC Fire-Crater Pistons and M&W normally didn't offer over-sized pistons for the number series tractors, just the letter series.
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
