Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: C123 Engine
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by justin on August 24, 2003 at 19:03:06 from (216.188.198.180):
In Reply to: Re: Re: Re: Re: C123 Engine posted by Hugh MacKay on August 24, 2003 at 17:32:30:
As far as the block being bored, I really don't think many people would go with having the bottom of the block bored and a new ring cut into the bottom of the block. I know this is rather cost prohibitive in the A thru C blocks when compared to purchasing a good used block, but I do know people who have done this on F12 & 14s to run 3-1/4" Clevite G275HCH assemblies for pulling tractors, but in that instance the cost didn't matter. I have probably sold over 100 sets of pistons and sleeves for the C113 & 123 engines and have never encountered a block that has been altered.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|