Farmall & IHC Tractors Discussion Board |
OK,Bob!(or anyone) I changed it! Heres results!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 49 Cubber! on July 28, 2003 at 15:25:37 from (206.74.216.73):
Replace cutout with a regulator and wired accordingly.(Used your diagrams of course)Only difference was I had no "L" terminal on the regulator I bought,so I wired it as if the OLD feild wire was the wire that would have been on the "L" terminal,but put that wire on the "BAT" terminal.Is that ok?! now results of the change over.Pull out hte switch,amp gauge drops to -6,start it up at half throttle gauge goes up to around 5 amps and at full throttle dead on 10 amps!Now at midlow to low idle I get a negative reading,-5 to-8,BUT the longer it ran the closer back to 0 it would get.After about an hour of running a low idle,it was at +1 or +2.I fiqured the battery had gotten low from al the starting I have been doing,so i let it sit for about 2 hrs and started it back up with the same -5 to -8 results and again the longer it runs the closer back to 0 it gets.What does that sound like? (I did polarize)
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|