|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: H Rebuild
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Steve - IN on July 24, 2003 at 18:25:34 from (12.223.205.149):
In Reply to: Re: Re: H Rebuild posted by SCCA SOLO on July 24, 2003 at 17:20:55:
SCCA Solo, The H doesn't corner very well -- what are you going to do with more high end horsepower? Couple of things -- step back and look at the cast manifold on ONE side (not cross flow) of the engine and the little carb on the inlet. Anymore questions on where the bottle necks are? Seriously, think headwork - by itself -- will do you little good without a tubular manifold and a bigger, or multi throat carb? And to take advantage off all that, you'll need more lift and duration on a custom ground cam, maybe a crank triggered igntion that's stable at high RPM?, etc. etc. Next question is why are you hot rodding it? The H engine is made to shine at high torque, low RPM situations -- and not high RPM horsepower. The whole engine and drive train is setup for torque, and not high end horsepower. I'd think you'll need to change a lot more things to take real advantage of more head flow. Re compression ratio -- you might get nearly the results at half the effort by using Occam's Razor -- that is, use white gas, Coleman fuel, etc. with lower octane that's matched to the engine instead of changine the engine to mate with higher octane gas. Sure, I understand where you're coming from -- 9 yrs Natl. License running FF, FC, FSV, FA and USAC mini-indy. I also have an H. It's designed for low end torque, not peak HP at 10,000 RPM. So for my money, you're better off rebuilding to a good stock setup with the H and getting your 3G turn jollies on something with a lower CG that was designed to rev high and run fast. Steve
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
