Farmall & IHC Tractors Discussion Board |
Re: Oil Pressure- Super A
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Randy in NE on July 09, 2003 at 09:22:32 from (216.58.237.20):
In Reply to: Oil Pressure- Super A posted by PGNS on July 09, 2003 at 08:46:51:
When the oil is cold you should have at least 1/2 to 2/3 deflection of the needle. When it warms up and is idling it will be lower. When my C (same engine) is warmed up and idling it goes to just a little less than half way which on my guage is about 25-30 lbs. I have about 70 lbs with cold oil pressure at max rpms. Replacing the oil pan gasket will have absolutely no effect on the oil pressure. As far as the metal plate that is most likely the plate on the bottom side of the oil pickup assembly for the oil pump. It floats in your oil so that the pump is not sucking the gunk off the bottom of the oil pan. This allows for fluctuations in the oil level due to oil draining back from the top of the motor, side hill operation, and for those that do not always check the oil level and the possibility of lower than recommended oil level. Not much to removing the oil pan and replacing the gasket. Good opportunity to clean all of the dirt and metal files from the bottom of the pan. The gasket is readily available from you local Case/IH dealer for just a couple of dollars.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|