Farmall & IHC Tractors Discussion Board |
Re: M Minimum Rear Wheel distance
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bud on July 08, 2003 at 13:05:14 from (152.163.253.102):
In Reply to: M Minimum Rear Wheel distance posted by Bill Perry on July 08, 2003 at 10:01:34:
I have no problems hauling my M on a 16 ft car carrier. The width inside the fenders is 82 inches which is pretty standard but they do make a trailer that is only 77 in so you better measure. You will need to set your wheels so they bow out which means you may have to switch them side to side in order to have the tread going the correct direction. My tractor had sat for over 30 years and I had no problem sliding them on the axles. There is a lot of slop once you loosen all four bolts. I would not try to remove them from the axle with less than three people. There heavy even without weights or ballast.Its not hard just take your time and be sure you have the tractor secured so it can't fall off the blocks.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|