Farmall & IHC Tractors Discussion Board |
Re: H Governor Rebuild ?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on July 07, 2003 at 10:14:31 from (165.170.128.66):
In Reply to: H Governor Rebuild ? posted by Matt K. on July 07, 2003 at 09:58:02:
Matt - First make sure it's not a carb mixture adjustment problem - an excessively lean or plugged idle jet can cause the symptom you describe. Test by very slowly pulling the choke closed while the engine is surging. If you find a choke setting that stops the surging suspect a mixture adjustment problem. If that doesn't do it next try loosening both ends of the horizontal tube connecting the governor riser and the carburetor. Loosen the pair of screws at both ends of the tube, wiggle it a bit to make sure it's free, then retighten the screws. If that doesn't help, then either something is binding in the linkage between the governor and the throttle shaft, or the governor mechanism itself is sticking. You'll need to peek inside the governor to find the problem...
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|