|
Farmall & IHC Tractors Discussion Board |
Re: Super A Frontend Axle Spacing
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by KeithF on June 30, 2003 at 08:49:02 from (67.37.213.65):
In Reply to: Super A Frontend Axle Spacing posted by scotty on June 30, 2003 at 06:47:05:
About a year ago I was doing the same thing to the axle tubes of a Super A. I don't think you want to use drastic measures like big presses to get it to release. It could end up bending the shaft. What I did (and it did work) was to spray penetrant into both ends of the tube and let it soak for at least a week. Spray it every chance you get during that time. It will cost a couple cans of penetrant. Also, I beat on the rusted area a lot with wood block to loosen up the rust and dirt. I got a lot of dirt to come out by doing this and that will help the penetrant to get to the rust. At the end of a week of soaking, I started heating the rusted area so that it was smoking the penetrant. I would beat on it then while it was hot to loosen up the rust. I would then try to make the shafts turn or move with a large pipe wrench (2 ft.). I it was still too tight I would let it cool and spray more penetrant in both ends and repeat the next day. I got both to eventually break loose and they will come out easier if you can get them to rotate so that the rust bonds will be broken completely. On both shafts I found the penetrant had made its way nearly to the center of the rusted area. By being patient and letting it soak down there it will eventually do its job and break the rust bonds when it is heated and expands.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
