Farmall & IHC Tractors Discussion Board |
Re: NEED MOWER IDENTIFIED
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by MD Wa. on June 27, 2003 at 20:31:35 from (67.3.85.95):
In Reply to: NEED MOWER IDENTIFIED posted by DANWV on June 27, 2003 at 19:36:44:
DanWV IH would use the same mower with differnt mounts. #16 was used on the A, B, H, and M, so would stand to reason that it would fit a C. I have never any ID numbers on my #16. Most part numbers on mine are from a #16. They came with 5,6, and 7ft bars. Have seen a couple with a 9ft bars. There should be part numbers on the big parts. E-mail me as I have a parts/owners manual if I can be of any help. Morgan
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|