Farmall & IHC Tractors Discussion Board |
Re: Farmall 560 Power steering please help!!!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Aces on June 25, 2003 at 08:00:29 from (67.0.6.188):
In Reply to: Farmall 560 Power steering please help!!! posted by big red 1 on June 25, 2003 at 07:01:55:
First thing is to make sure the steering shaft is not tight because the shaft comeing out the back of bolster houseing must move in and out to open the hydraulic valve, I would check that with the engine off just rock the steering shaft back and forth to see if the shaft moves in and out.It should move in the splines of the u joint but if that spline is rusted tight there is a ste coller under the hood that you can move away from the housing to fix that. If you find things ok then I would think it would be in the bolster there is a ball rack and pion in the steering rack it could be bad I would not think it would be the rack gear or the bolster shaft because say it is the same right or left. hope this helps
Follow Ups:
Home
| Forums
Today's Featured Article -
The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|