Farmall & IHC Tractors Discussion Board |
Re: Convert 300 to 12volt system ??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Doug in OR on June 24, 2003 at 11:20:43 from (159.121.94.198):
In Reply to: Convert 300 to 12volt system ?? posted by Dave K. on June 23, 2003 at 21:36:14:
A common mistake many people do is that they substitute 12 volt battery cables for the existing 6 volt cables. Six volt cables are heavier and have less voltage drop at the higher currents. Check your cables first - ensure they are the nice heavy cables you would find in a 6 volt system. While doing this, clean all connections completely. If the ground cable is bolted to the frame, undo this bolt and clean everything. The tractor frame. The cable terminal. The bolt. Hidden corrosion is the usual culbrit. One last thing to look at is the starter itself. You might have worn brushes or bad bearings. Two other items: Yes, 8 volt batteries do exist. As you've found, locating a charger for them is more difficult. Finally, converting to 12 volts is no big deal. I would not do it simply to mask another problem, though.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|