Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Factory cultivator options
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on June 19, 2003 at 03:58:18 from (209.226.247.129):
In Reply to: Re: Re: Re: Re: Factory cultivator options posted by Dick Davis on June 19, 2003 at 03:18:16:
Dick: I will not argue with you on that one. Geographically there has been a lot of difference in terminology. I had a guy respond on another thread couple of days back, he said in reference to W series tractors." Here in the deep south we called the W series tractors Wheel Tractors whereas you people in the north called them Standards". I really didn't respond to that, although I have never seen anything to indicate W in a W series tractor stood for Wheel. It did however say STANDARD on the decal. I always thought that was a reasonably good reason to call them Standards. I will say also I always found it quite reasonable to call all wheel tractors, WHEEL TRACTORS. Now I do question Mc Cormick being used to identify a specific tractor. Mc Cormick was on most decals well into the 1960s. My current Farmalls SA, 130 and 140 all have Mc Cormick on their original decal. In the past I know my Farmalls 300 and 560 had Mc Cormick on decal. I am reasonably certain it was on my 504 and 656. I am positive Mc Cormick was on one of them. I dare say it was on all standards and later utilities well into the 1960s. The whole system used on IH tractors was quite redicuolous. Just look to left of this screen and the possible MAKES listed for IH tractors in the serial numbers listings.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|