Farmall & IHC Tractors Discussion Board |
Re: 4-Position Switch to Charging Problems
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Fred KS on May 15, 2003 at 18:30:50 from (64.39.205.3):
In Reply to: 4-Position Switch to Charging Problems posted by Farmall Don on May 15, 2003 at 18:09:50:
Don, Sounds like you will have to polarize your electrical system. Anytime you disconnect the leads from the generator or regulator you will have to polarize them to get the juice flowing again. This is done prior to starting the tractor. If you have a POSITIVE ground system, momentarily connect a jumper wire between the "BAT" terminal on the regulator and the "A" terminal on the generator. Do not touch the "F" terminal on the generator or you could damage your regulator. Hope this helps. Fred KS
Follow Ups:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|