Farmall & IHC Tractors Discussion Board |
4-Position Switch to Charging Problems
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall Don on May 15, 2003 at 18:09:50 from (64.83.160.22):
Thanks Bob M (& others) for the advice. I obtained a 4 position switch to keep the wiring the same. The problem I have now is that the generator is not registering a charge on the amp gauge. I turn the lights on and it discharges to minus 10 amps. I turn them off and its back to zero. I did mix the ignition switch wire with the wire from the generator (working too fast). Could this have done anything? I quit for the night, but plan to test the generator to see what it is producing tomorrow. I cannot believe the generator would just stop working by replacing a switch?? Also, I should mention I believe I have a voltage regulator. It is a box that looks like a regulator with three terminals coming off of it. It is mounted on top of the generator. Any advice would be apprieciated. Thanks
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|