Farmall & IHC Tractors Discussion Board |
Some tactics on getting a motor unstuck?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall Daddy on March 25, 2003 at 17:37:24 from (209.183.116.214):
I came across 2 1953 Super M's in the paper. They want $1000 each, they are both stuck, and they are complete. How are some ways on how to loosen a block. I know that there is many ways on how the motor could become stuck, such as no oil, main bearings, etc. I have heard that you remove the head, fill the head with kero and leave it set a few days, then try to crank it over by pulling it. Another person {John Deere man}, said that you remove the head, if the piston is at the bottom, put cotton balls in the block, fill with kero and then diesel, have a sledge hammer with a board that would fit down in the block, light the fuel on fire, and start pounding away. It is supposed to exspand the piston, crack the rust, and therefor help release the piston. Like to own a Super M for a loader tractor. Any ideas is appreciated!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|