Farmall & IHC Tractors Discussion Board |
Re: Exhaust Questions for F-20
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Smith on February 21, 2003 at 10:30:15 from (128.242.4.59):
In Reply to: Exhaust Questions for F-20 posted by Dave in GA on February 21, 2003 at 08:42:37:
The origainal manifold for the dual fuel burning F-20 I believe had the larger exhaust outlet pipe. The after market manifolds and perhaps the original gas burning manifolds had a smaller exhaust outlet pipe. Originally with no muffler the F-20 had a caste iron elbow that shot the exhaust out to the side and didn't extrude out of the hood with much height. The original pipe I am sure had a set length and the elbow I believe clamped right on to that. It seems to me that the top of the elbow on an original set up was just guessing in the 6 inch range above the top of hood. It doesn't come out of the hood very far before it bends.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|