Farmall & IHC Tractors Discussion Board |
Exhaust Questions for F-20
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave in GA on February 21, 2003 at 08:42:37 from (163.246.18.120):
Here's one for the exhaust experts. I have a 1936 F-20. The outlet hole on the tractor's exhaust manifold measures about 2 1/2" in diameter. I have a spare manifold which came with the tractor which looks the same but has a larger outlet hole that's about 2 7/8". Meanwhile, I have a cast iron exhaust elbow with the inside mounting diameter being about 2 3/4". Which manifold should be on the tractor, the one with the larger outlet or the smaller one? Also, to properly install the elbow at the correct height, how many inches of exhaust pipe should there be from the manifold to the base of the elbow?
Follow Ups:
Home
| Forums
Today's Featured Article -
The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|