|
Farmall & IHC Tractors Discussion Board |
Re: Need alittle basic technical information on Farmall 300 or 350 fast hitch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on February 17, 2003 at 02:08:30 from (216.208.58.173):
In Reply to: Need alittle basic technical information on Farmall 300 or 350 fast hitch posted by Ray in PA. on February 16, 2003 at 22:49:50:
Ray: I don't know if I dare say boo. My 300 would not lift its rear wheels off ground. It would come close. I think that without wheel weights and calcium chloride it would raise the rear wheels. A neighbor had a 200 and it would lift rear wheels. On the lift above and below ground level, you are talking 16-20 inch range, 2 feet behind hitch point. You should obtain that range easily enough. One fault I found with fast hitch is they would never raise implements high enough without modifications. Below ground level was never problem. All tractors of that configuration whether it had fast hitch or 3 point had the not lifting high enough problem. Blade wouldn't be a problem, but many implements would strike the seat.
Follow Ups:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
