Farmall & IHC Tractors Discussion Board |
Re: No.45 and No.46 balers ?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on January 12, 2003 at 17:24:27 from (209.226.106.188):
In Reply to: No.45 and No.46 balers ? posted by Wardner on January 12, 2003 at 15:11:08:
By self powered I presume you are talking engine driven as oposed pto, and still pulled by tractor. All the models that were pto driven could be engine driven. Most of them used a weight much like a wheel weight added to the flywheel. The mounted engines powered the baler by flat belt over flywheel. The 45 baler was pre some where around 1956 and the 46 was the replacment that followed. I wont argue with previous post, 45 was junk, 46 was a good baler. Pictures I have also seen on the electrall, used the 55 baler, a much larger and higher capacity baler. Seems to me I remember a model 56, however its not pictured in CH Wendel's book, 150 Years of IH. What Mr. Wendel does say of electrall is," After its initial anouncement, little was heard of the Electrall unit.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|