The clutch is held on to the outside of the flywheel by 6 bolts. There is a remote chance that you have to insert bolts into the clutch housing to hold the pressure plate together during removal. My SH does not have those, I think that is true of the later Rockford clutch that is on your tractor. Once you remove the clutch, the bolts for the flywheel are evident. As a caution, the flywheel is heavy. I usually put a block under mine in case I drop it. If you have the flywheel machined, be sure to have the machinest take the same amount off the step that the clutch bolts to as he does from the flywheel surface. I think the official spec from the flywheel surface to the step is 1.188 inches. The best buy you will find on a rebuilt clutch (pressure plate and disk) is from Steel Wheel Ranch, about $200 minus a $24 core charge plus shipping for my 460, about the same clutch. Includes pilot and release bearings. 785-548-7437.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
