|
Farmall & IHC Tractors Discussion Board |
Re: 1950 C touch control question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on October 15, 2002 at 04:36:01 from (128.59.123.240):
In Reply to: 1950 C touch control question posted by DAN WV on October 14, 2002 at 22:41:35:
Dan, give Hugh's suggestion a shot first, and you might just double check your fluid level. You should probably also check the condition of your strainer (the temp sending unit mounts in the middle of the end of it on the left side)and clean or replace as necessary. If none of that fixes it, I suspect you're going to have to rebuild the controls. Mine was the other way around - went forward easily, laboring on the back stroke. You can get a rebuild kit from a CaseIH dealer. It's mostly O-rings (lots of 'em!) and a couple of gaskets. It's not a small undertaking, but can be done at home. There is a Service Manual you can get just for that unit that you should have at your side as you work -- invaluable in figuring out just where that little spring rolling around on your benc (or under it!) came from. Probably the most important factors are patience getting things apart (it goes back together easy) and having a clean place to work. Clean up in there as you go and keep everything very clean as you put it back together.
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
