Farmall & IHC Tractors Discussion Board |
1950 C touch control question
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by DAN WV on October 14, 2002 at 22:41:35 from (66.190.189.232):
My 1950 C had three rotating arms on the hydraulic system and they were in sad shape to say the least. When I got the tractor the hyd. system made the engine labor more when the arms rotated forward. When they rotated back it seemed much easier. I assumed it was because the arms were so mangled and rewelded. You could see them rubbing on one another. I have since found a perfect set from a 1949 C and replaced the arm and shaft assemblies only, leaving intact the factory reservior and cylinders. The same thing is happening, When they rotate forward they really drag the engine down and rotate effortlessly reward. Is there something wrong with the system or is this just the nature of the beast?
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|