Farmall & IHC Tractors Discussion Board |
Re: Re: Re: engine dies on cub
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on October 13, 2002 at 16:19:59 from (216.196.13.44):
In Reply to: Re: Re: engine dies on cub posted by pmtoolbox on October 13, 2002 at 12:19:28:
What i mean is do you have to much timimg at full throttel i always check the curb idel timing at the slowest that i can get the engine to run at then i check the total adv. at full throttel and see if the advance is doing what it is suppose to . I know that there is no fuel adjustment on a cub carb but some time a small pice of dirt or rust can block that jet and lean them out. And as far as the clearance on the skirt to wall i would have to look into my books but i think it is a shade to tight . All ya can do is let it break in a littel more on lite work and see if it losens up but there are some things to check . I know that the new machinest of today like to build them tight but this is not a car engine . Anoter thing try some better gas in it 87 octain burns hotter then the 89 or 93 and make sure that it is 100% pure gas as the stuff with alcohol will lean out when it burns.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|