Farmall & IHC Tractors Discussion Board |
Re: Re: C123 Block Boring
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Stan(VA). on August 29, 2002 at 05:06:23 from (208.59.156.179):
In Reply to: Re: C123 Block Boring posted by gene b on August 29, 2002 at 04:16:00:
Gene, The 3 1/4" pistons already come with the thinner sleeves so there's no room to take any more off! If it helps, I allways thought all C123 blocks were the same as far as sleeve openings, but found that on these later motors IH went back to the smaller opening like in the C113 block and just sent them from the factory with the same overbore kit you would use in a C113. What I'm trying to do is more like fit a straight C's C113 block for the overbore sleeves that are for a Super C's C123 block. Thanks, Stan(VA).
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|