|
Farmall & IHC Tractors Discussion Board |
Re: Re: Help, Oil Change reveals problem, Super C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Don on August 28, 2002 at 21:56:02 from (208.11.82.186):
In Reply to: Re: Help, Oil Change reveals problem, Super C posted by Paul Shuler on August 28, 2002 at 14:55:53:
Paul, unless I am misunderstanding you, could you give a little more information on where this hydraulic pump is located and how it would cause extra oil in the crankcase. The stem was twisted off for checking the high level of the engine oil. This got me to thinking that the previous owner was unsure of himself and was adding oil when he should not have been. For your info my parts catalog for this tractor shows what it calls a ring packing, cylinder sleeve and is shown at the bottom of the sleeve. The parts counter where I purchased this manual said this manual was for the super c even though the first page says farmall c and I was given a small sticky tab to affix on this first page saying Super C. However, this manual also shows a gasket on the oil filter and my tractor does not have a gasket. Where the filter case makes contact with base there is a tappered groove. Makes you wonder. (I just now noticed that the 2nd and 3rd pages of this manual does say super c on them)
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
