Farmall & IHC Tractors Discussion Board |
706 3pt wont lower
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmall Don on July 14, 2002 at 15:08:10 from (64.83.160.22):
I finally started looking into why my three point wont lower. I put a pipe wrench on it and get it to lower about four inches. It will bob up and down another two inches, but wont release. I took the top link bracket plate off and everything seems to be working. The cylinder goes in and out with the force of the pipe wrench, but wont release. Could this be a bad valve in the hydraulics. It seems to me to be air making the cylinder pressure soft. I wouldnt thing hydraulic fluid would allow it to be soft??????????????????? Also, when you get it to lower the four inches, the cylinder will lift it back up and when I release it just goes to the same spot.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|