Farmall & IHC Tractors Discussion Board |
Re: farmall h oil pressure gauge
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ca on June 13, 2002 at 11:32:43 from (207.54.105.157):
In Reply to: farmall h oil pressure gauge posted by Bob on June 13, 2002 at 10:16:25:
If the gage is not leaking and is giving a proper reading it must be ok. Try another gage and see if it gives the same pressure readings. The gage pressure not going down untill you crack the feed line open. Tells me the pressure is not bleeding down in the engine block after you stop, Or did somebody but a check valve in the feed line "check". Dirt or forren material in the feed line mite act like a check valve, But it's not likely. This could cause a proplem if your running the engine and the oil pressure drops due to low oil level,plugged filter or oil pump quits etc, And the gage stays up you will think oil pressure is good. And then hear the engine knocking. Good luck and let us know
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|