Farmall & IHC Tractors Discussion Board |
farmall h oil pressure gauge
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on June 13, 2002 at 10:16:25 from (166.102.96.8):
The oil pressure gauge on my farmall h been sticking all the way up even after it is shut off. So I tried taking the line off the gauge and as soon as I loosened the line up about 2 turns the gauge went down, so I took it off and sprayed wd-40 in the gauge and the line and reassembled it, started the tractor and the gauge did the same thing. So I tried loosening the line a little bit until the gauge went down and then started it and oil poured out of the line, so I know it has pressure. Do you guys think my gauge is shot? I am trying to save it because it is the orginal! Any ideas would be appreciated! Thanks in advance! Bob
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|