Farmall & IHC Tractors Discussion Board |
Steve Mason ---- hand crank
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jtwaldo on May 20, 2002 at 10:39:50 from (199.79.251.179):
Here is what I got when I measured my hand crank for the 200. ignore the periods. the html ignors spaces so i have to put something there to draw the picture. .. the steel rod is 3/4" in diameter. .. It is 17 1/2" long. .. Bends down 90 degrees it goes down 8 1/2". .. Bends bends 90 degrees again and goes straight ...for 5" .. 3/4" from the end (on the 17 1/2" part) there is a 3/8" rod that goes through the 3/4" rod. it sticks out about 3/8" on either side of the 3/4" rod (sorry forgot to measure this but that should be right). ..........17 1/2" ....----------------- ..............................| ..............................|8 1/2" ..............................| ...............................------- 5" ..3/8" diameter rod sticking out 3/8" ........ on either side .......|.| ..---|.|----------- 3/4" diameter rod ..---|.|----------- .......|.|
3/8" rod 3/4" back from end hope this helps
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|