Farmall & IHC Tractors Discussion Board |
Re: Re: Steve Mason ---- hand crank
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Word of CAUTION. on May 20, 2002 at 12:23:39 from (65.56.56.127):
In Reply to: Re: Steve Mason ---- hand crank posted by Steve Mason on May 20, 2002 at 11:57:22:
Steve: I just had to find mine from a '48 model and the pin on the end is 5/16 and same length of 1 1/2 inches. all the rest is the same except that the factory has a bushing grip so your fingers do not have to slip\slide around as you spin the crank. For all 'newer to cranking' people,.. DO NOT WRAP your hand with thumb in opposing direction around crank. During a kickback it'll break that thumb so quick it isn't funny. Keep thumb in same direction as fingers. A kickback will then be freerer to come out of your grip. Hurting only your pride and not breaking an arm.
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|