Welcome! Please use the navigational links to explore our website.
PartsASAP LogoCompany Logo (800) 853-2651

Shop Now

   Allis Chalmers Case Farmall IH Ford 8N,9N,2N Ford
   Ferguson John Deere Massey Ferguson Minn. Moline Oliver
 
Marketplace
Classified Ads
Photo Ads
Tractor Parts
Salvage

Community
Discussion Forums
Project Journals
Your Stories
Events Calendar
Hauling Schedule

Galleries
Tractor Photos
Implement Photos
Vintage Photos
Help Identify
Parts & Pieces
Stuck & Troubled
Vintage Ads
Community Album
Photo Ad Archives

Research & Info
Articles
Tractor Registry
Tip of the Day
Safety Cartoons
Tractor Values
Serial Numbers
Tune-Up Guide
Paint Codes
List Prices
Production Nbrs
Tune-Up Specs
Torque Values
3-Point Specs
Glossary

Miscellaneous
Tractor Games
Just For Kids
Virtual Show
Museum Guide
Memorial Page
Feedback Form

Yesterday's Tractors Facebook Page

  
Farmall & IHC Tractors Discussion Board

Re: Re: Help Bob M. rewired 130 today


[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Hugh MacKay on April 15, 2002 at 05:52:30 from (209.226.106.99):

In Reply to: Re: Help Bob M. rewired 130 today posted by Bob M on April 14, 2002 at 19:28:32:

Bob: As you may or may not recall with the number of questions you recieve. My tractor is the one that trucking company left switch on during moving. Tractor arrived with cooked battery, original wireing harness melted. I had installed a new battery just before move so they wouldn't have trouble starting. Yesterday I installed a new Battery, 520 cranking amps, showing 12.5 volts at installation. I put all new wires on tractor as per your diagram two wire with alternator H & M. My tractor is a 130 so assume only difference is solinoid versus start lever on 130. I did not check out ampmeter or alternator as I have to drive some distance to do that. After starting tractor, I checked at several points with voltmeter and was getting 12-12.5 volt reading. After I shutt tractor off I put volt meter on at alternator, with tractor not running and ign. switch off I got 1-2 volt reading. Thinking that shouldn't be I removed ground from battery came to house, posted for your help. Upon reading your responce this am I went to shop connected battery, started tractor, after a bit of warm up I removed battery ground, tractor stoped immediately. I repeated and same thing. Ampmeter guage also does not go to neutral as it used to when tractor is shutt off. The ampmeter hand does move several points + when tractor is started and goes to + 5 when tractor is off. Two questions, 1. Should I have gotten that 1-2 volt reading at alternator with tractor off. 2. Tractor stoping when I removed battery ground leads me to believe alternator is not working. Is this alternator or just internal regulator. Also the fact that I did not get the 13-14 volt reading you speak of with tractor running, reinforces the thought that alternator is not working. I hope this gives you more to work with. As always thankyou very much for your responce. Hugh


Follow Ups:




Post A Followup

:
:

: Re: Re: Re: Help Bob M. rewired 130 today

:

:

:

:

: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.


TRACTOR PARTS TRACTOR MANUALS
We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]

Home  |  Forums


Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro ... [Read Article]

Latest Ad: Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request [More Ads]

Copyright © 1997-2024 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy

TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters

Website Accessibility Policy