Farmall & IHC Tractors Discussion Board |
Re: Bad clutch release bearing???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ScottyNY on April 03, 2002 at 13:19:25 from (128.59.123.240):
In Reply to: Bad clutch release bearing??? posted by Bama Binder on April 03, 2002 at 08:56:25:
Binder, is you rr elease bearing a conventional type bearing that looks about like any other, or is it of the old graphite block type? If the latter it may be worn down enough that you're out of adjustment room. If it is a regular type bearing, it being bad wouldn't keep you from disengaging the clutch. It may be the fingers need adjusting like others have suggested, if the design allows for it. Just thinking back to suggestions some folks made about the similar problem redrev is having with his M clutch not disengaging (We're going to get after that, folks, as soon as his shop warms up!), is it possible your clutch disk is in backwards? If the splined center of the disk sticks further out one side than the other and you've got it on in the wrong direction, the longer side could interfere with disengaging. Something else to check out. Good luck. Scotty
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|