Farmall & IHC Tractors Discussion Board |
Re: Timing an H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob - w/link to photo that might help on February 03, 2002 at 08:45:37 from (66.66.72.246):
In Reply to: Timing an H posted by Dick Davis on February 02, 2002 at 15:51:28:
Hey Dick - The cam timing marks on my Super M consist of a prick punch between two teeth, and what looks like a pair parenthesis...looks like this: ( )...exactly 180 opposite. Neither mark is very prominent. I presume the H is similar. If you lay a straight edge across the face of the gear and 90 deg to the keyway, the prick punch mark will be exactly 1 tooth counterclockwise from the straight edge. (Punch below for a photo of what I'm trying to describe...) If memory serves me correct (no guarantee here!), the timing mark on the crank gear is a bevelled tooth that aligns with the crank gear keyway. However if you cannot find crank gear mark, set the crank with #1 piston at TDC, then install the cam gear so either of the timing marks is opposite the crank gear tooth in mesh with the cam gear. That should find the marked crank gear and you should have it. Hope this helps, and good luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|