Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Timing an H
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob M on February 04, 2002 at 18:55:13 from (66.66.72.246):
In Reply to: Re: Re: Timing an H posted by Dick Davis on February 04, 2002 at 17:31:11:
Hey Dick - I think I understand your problem! It's been a while since I was inside the timing cover on the Super M. But as I recall the crank gear timing mark was either a beveled tooth or a punch mark on a tooth. Reviewing my photos, it looks like when the crank is at #1 TDC, the crank gear timing mark is 4th tooth going counterclockwise from the top. I.E. if we call the tooth on top of #1, the timing mark is tooth #4 counting counterclockwise. And to add to the confusion, it looks as though the crank gear keyway is at about 7 o'clock when the crank's at #1 TDC. But again it's hard to tell for sure from my pix. Anyway contact me off board if this doesn't help - perhaps there's another way to figure this thing out. ...Bob M
Follow Ups:
Home
| Forums
Today's Featured Article -
Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|