Posted by rustyfarmall on March 23, 2009 at 13:28:15 from (209.152.78.140):
In Reply to: Carb rebuild posted by ed in cny on March 23, 2009 at 12:44:15:
ed in cny said: (quoted from post at 12:44:15 03/23/09) I would like to do a 300 carb rebuilt. Best place to get it parts is? I see alot of basic kits but would like to go completely through carb. I called to have it done someplace else but seamed like to much. Would like to see if I could do the rebuild myself if I could find the parts. I've done others and it shouldn't be to hard. If anyone could direct me to kit with all the parts in it that would be great.
There are no complete kits for the Super H, 300, or 350 carburetors. Your best hope is to buy a complete kit for a Farmall M and then throw away the new choke shaft that is in the kit, because it will not work on a 300.
And while we are on the subject, how much is too much for a rebuild?
This post was edited by rustyfarmall at 13:29:27 03/23/09.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.