Farmall & IHC Tractors Discussion Board |
Re: 424 loader/ hydraulic question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Dave in Southern Illinois on June 19, 2007 at 11:10:04 from (216.138.60.195):
In Reply to: Re: 424 loader/ hydraulic question posted by IH2444 on June 19, 2007 at 08:43:06:
How difficult is it to replace the seal on the work piston in for the 3 point on a 424. I have the hydraulic housing off to replace the pinion seals and was going to replace the seal on the 3 pt work piston. My I & T manual give some instructions but when I took the top cover off and looked inside I got cold feet. It seems that there are alot of linkages and a spring and a chain that has to be unhooked before the control valve and cylinder unit can be removed. I didn't want to take it all apart and not be able to hook everything back together again. There doesn't look to be very much room inside there to disconnect everything that has to be removed in order to pull the cylinder. Any tips would be greatly appreciated.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|