Farmall & IHC Tractors Discussion Board |
Governor Repair Request
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob T. (Farmall Rookie--- on June 18, 2007 at 03:39:43 from (24.91.165.8):
In Reply to: H Governor?????? posted by cordell huebsch on August 29, 2004 at 17:39:27:
Would someone who has a scanner is familiar with Governor "Trouble Shooting" put up on this bulletin board a complete hand drawn diagram of the Farmall H Governor design with component parts and its interface with the carburator indicating the places where things go wrong and the remedies tagged to these trouble spots where metal wears. Perhaps YT Company might do this as a service to parts buyers. One has to read through all the "Governor" postings to get a sense of the difficulty controlling the "Idle Speed" to remedy the "Hunting for the Right Speed" on the Farmall H and even then it is not an easy repair that is for sure. Lastly, must the governor shaft be hand machined as they are not available?
Replies:
Home
| Forums
Today's Featured Article -
The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|