Farmall & IHC Tractors Discussion Board |
Re: H rear end update.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob Kerr on June 16, 2007 at 22:31:15 from (64.12.117.8):
In Reply to: Re: H rear end update. posted by georgeky on June 16, 2007 at 21:35:05:
I really can't wait to get it done. yep, when I get this one done, I may just have to open up an H tranny shop! One thing though I found out today at the bearing place that the pilot bearing (43356DA) on the main shaft is getting VERY hard to find. I would get one of those now and put it somewhere for later. we had to order it out of a bearing house in Texas that specializes in obsolete bearings and not one manufacturer is making them so when they are gone, they are gone. If you want one let me know and I will give you the contact info. I had some trouble with my M clutch a while back, one bolt came out of the coupler and both bolts came out of the throwout bearing sleeve. I noticed a few days ago it is making a clicking sound also when under heavy load. I may have to tear back into that and figure it out also.
Replies:
Home
| Forums
Today's Featured Article -
Women and Tractors - More Views From the Farmer's Wife - by Teri Burkholder. The top ten reasons why the judges wouldn't let you participate in the stock antique tractor pull: Hey, this is stock! It came with that V8 in it! That "R" on my tires stands for "really old" not radial! Blue gas? We thought it was a pretty color! What wire hooked to my throttle?
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|