Farmall & IHC Tractors Discussion Board |
Re: 46 bale pickup cylinder broken
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Karl Hamson on June 12, 2007 at 07:31:42 from (139.142.96.209):
In Reply to: 46 bale pickup cylinder broken posted by zldwest on June 11, 2007 at 19:18:49:
I has a similar problem with my 46. Turned out that the cam track had worn right through and one of the cams was going through the worn track, causing the whole thing to sieze up. They are not easy to work on. I found the best was to remove the entire pickup, unbolting it from where it pivots underneath by the axle. From memory this is a welded up assembly and the only way we could get at the cams and track was to torch it apart. We then made up a new cam track strip from cold rolled steel and welded it in. Then welded the pickup back together. Before you get in to ripping it all apart try taking the drive chain off and see if it will turn then. The problem could be in the drive chain assembly which tends to get overlooked when greasing as you have to crawl under the baler to get at it. Good luck! Karl
Replies:
Home
| Forums
Today's Featured Article -
Identifying Tractor Smells - by Curtis Von Fange. We are continuing our series on learning to talk the language of our tractor. Since we can’t actually talk to our tractors, though some of the older sect of farmers might disagree, we use our five physical senses to observe and construe what our iron age friends are trying to tell us. We have already talked about some of the colors the unit might leave as clues to its well-being. Now we are going to use our noses to diagnose particular smells. ELECTRICAL SMELLS
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|