|
Farmall & IHC Tractors Discussion Board |
Clutch pedal wobbles
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CopelandJ on June 11, 2007 at 13:29:13 from (134.161.228.210):
I sure need help. The clutch pedal on the Super M I"m working on wobbles terribley on the shaft -- as much as four inches side to side. The IH dealer showed the diagram related to this, and he says there was nothin on the shaft originaly to keep it from wobbling. He said the shaft is just worn, but the shaft sure doesn"t look worn. My guess is there was an insert of some type on the inside of the pedal where it is on the shaft that kept it level and without wobble. Since the IH dealer says there is no fix for this, I"ll have to find out what others have done to take care of this. Should I just put washers on the shaft on the inside toward the tractor to try to take up some slack so that the pedal doesn"t wobble so much, or should I machine something to put in the pedal housing where it goes on the shaft -- or on the shaft itself to take up the wobble? Any help will be greatly appreciataed. Take care. Jeff
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
