Farmall & IHC Tractors Discussion Board |
656 Axle Seal - Felt Needed? (pic)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by North TX 656 on June 09, 2007 at 22:02:32 from (71.48.165.233):
You can see by the size of the puddle in the drive that the drip was pretty steady. That's about two weeks worth on the driveway. There was poly twine wrapped around the axle when I bought it; I hope that was the cause of the seal failure because there is also a grove in the axle. #1) A felt seal is not listed in the online Case/IH parts catalog but my dealer sold me one based on his parts lookup. ($12). Also, there was no felt washer found during disassembly. Should I use one? #2) Wish dealer would have clued me in on the o-ring. Wasted 1/2 hour in town today trying to track one down; nothing large enough. The information in the archives was right (as usual), this job has been pretty easy but without the o-ring I won't be able to finish until Monday or later. Arrgh! #3) I'm going to try to seat the new seal at a different depth as per the archives. #4) Any other tricks or tips to give this repair a good chance of working? Thank you.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|