Farmall & IHC Tractors Discussion Board |
Re: cam gear super m
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hayfarmer on June 03, 2007 at 09:22:10 from (66.243.239.215):
In Reply to: cam gear super m posted by point3dave on June 03, 2007 at 05:34:46:
Not too bad a job if you have access to a loader or something to lift the front end. I had to change the camshaft on my smta a while back. The gear loostened up and put it out of time. I blocked up the motor and used my tractor loader to pull the steering bolster, radiator assembly out. You have to losten frame bolts. It is a little harder to put back together and definitely works better with 2 people. While you have the front end off check or replace belts. Another problem is getting crankshaft pulley off. When you get it together you have to time the gears. Oh, and before you put the front cover back on don't forget that little tin oil flinger on the crank shaft.
Replies:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|