Farmall & IHC Tractors Discussion Board |
Re: Farmall C Fluids
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by achodges1 on June 01, 2007 at 19:10:13 from (68.88.137.32):
In Reply to: Farmall C Fluids posted by ed342 on June 01, 2007 at 13:18:13:
The transmission PTO and differential share the same fluid. If you have a belt pully drive it has its own supply. The fill plug is the large plug in the deck. The "round" hole in the top used to be a Square hole that would take a 1/2" drive rachet or breakover bar. The axel housings are supposed to be dry with the inner bearing lubricated by the oil in the differential and the outer bearing lubed by the grease zert. The seals on the inner bearing leak oil into the axel carrier and out the outer seal. Takes 5 gallons to fill it up 90W gear lube. If the plugs have eroded to the point that the holes are round you may have to drill a hole and use an ease out to get them out.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|