Farmall & IHC Tractors Discussion Board |
Re: BIG problumes with MD?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jonnnny2006 on May 31, 2007 at 22:15:59 from (67.142.130.33):
In Reply to: Re: BIG problumes with MD? posted by the Uforgiven on May 31, 2007 at 21:03:29:
im talking about when the mag is off compleatly. the part the mag bolts into and makes the mag turn does not rotate with the engine as it should. ive never seen one apart before but i would imagin that if the part that spins the mag isent turning with the motor then there is no way it can get spark as the mag wont turn eather than. It would be like a broke drive shaft on a car. there nothing wrong with the rear end but yet the rear end wont turn, its because a broken shaft. well the same thing is happning with my mag there is nothing turning it no more as the part that normally turns the mag isent turning. thus not turning the mag. so when i dint see the rotar turn i thought it would be because it wasent mated correctly, but that is not the problume. i'll have to tear into it to see if there is somthing broke in the peace thats turns the mag. that part looks like it unbolts from the block.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|