Farmall & IHC Tractors Discussion Board |
Re: rear axle seals
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Haas on May 28, 2007 at 10:23:10 from (12.65.60.149):
In Reply to: rear axle seals posted by marty johns on May 27, 2007 at 18:07:35:
Not too difficult to do. I'm not sure of the cost for the seals and gaskets you need. Probably on the order of $100 for both sides. If you do both sides, I suggest one at a time, as the these offset tractors get a bit unstable when both rear wheels, etc are removed at the same time. Basic sequence it rmove wheeel and hub, remove final drive pan, remove 4 bolts from seal holder/axle bearing retainer at outside end, remove axle cover on inside of final drive, remove axle retainer bolt and drive the axle out. Put something under the bull gear to keep it from falling out. Best to get a service manual and parts catalog so you can see how things go.
Replies:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|