|
Farmall & IHC Tractors Discussion Board |
Farmall MD questions!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by jonnnny2006 on May 18, 2007 at 20:02:17 from (67.142.130.15):
If any one can help please i would be very greatful. I am going to buy a MD on sunday... The guy im buying it from says that it wont start. He ran it the day before. He told me it died on him and then would not start back up. what i dont know if it died when he was running on diesel or on gas. but if it did die on diesel and lets say the diesel pump quit shouldnt it still start on gas? It dooes have a magneto for the gas to fire on. I think if it is not getting spark i will check the mag and wires. My question is just because it wont start on gas does that mean it wont run on diesel eather? i know you are supposed to warm them up on gas then switch. but can a guy pull start it right off of diesel. it is supposed to be 80 out on sunday when i go get it. If I pulled it around for a while with it on the gas side of the motor with the gas valve off at the tank I was thinking that i could warm the engine up that way enough to make the diesel fire. does this sound like somthing that would work? I had a guy tell me that he had pulled a minneapolis moline that was supposed to warm up like the md and he said it took a while but it did start. Any suggestions would be a big help as I would like to get it running so i can load on my gooseneck trailer without tring to push or pull it on. Also... am i right that when you wanna stop the md you just idle it down till it kills as there is no "kill" switch. or is there a kill switch? i do not know alot about the MD. I just know they dint make nearly as many as the reguar M. Thanks for any info!
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
