Farmall & IHC Tractors Discussion Board |
Re: M cast iron shift knob, old seat, etc.....
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nat 2 on May 17, 2007 at 07:33:26 from (64.80.110.50):
In Reply to: M cast iron shift knob, old seat, etc..... posted by Patrick martin on May 16, 2007 at 21:12:21:
Serial number is on a thin metal plate that is riveted to the bell housing. That is the large casting bolted to the rear of the engine. Some people mistakenly call it "transmission." If anything, there should be evidence of the plate there. Four holes or four rivet heads or the leftovers of the plate. If it's been removed you will never know the exact serial number. The engine serial number is on a machined flat spot below the spark plugs. That will be CLOSE, but not the same. Grab some casting dates. These are cast on the larger pieces like the engine block and are in the format of 11-22-X; two numbers, and a letter. 0 is 1945, N is 1944, M is 1943, L is 1942.
Replies:
Home
| Forums
Today's Featured Article -
Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|